I've read alot of your posts. It's obvious you are or were a Miller tech. I was wondering... is it possible to make it into a dual power machine in the spirit of a pipepro 304. That is, run a disconnect from the lugs of the generator that delivers arc power. Then add a three phase 240 V plug to the other side of that disconnect... and finally add an electrically driven (always on) cooling fan for airflow inside the chassis. That way you can run off of shop current without having to fire up a loud engine and breath fumes.
Announcement
Collapse
No announcement yet.
Visitor Messages
Collapse
X
-
XMT 350 w/ S-75 DXA Feeder
and a Bernard 300 gun
Optima Pulsing Pendant
XR-W wire feeder + Coolmate 4
with an XR-W Edge Gun
Passport Plus w/Spool Gun
Regular Passport
Dynasty 200DX
Trailblazer 301G w/Freak Box &
S-32P volt sensing wire feeder
Spectrum 1000 Plasma
Spectrum 375 Xtreme Plasma
Regular Spectrum 375 Plasma
Victor H315FC torch & accessories
Victor 100FC torch & accessories
Meco torch & accessories by Kent WhiteTags: None