Announcement
Collapse
No announcement yet.
Lathe milling.
Collapse
X
-
small cutter in er40 collet chuck
1 PhotoTags: None
-
cutting slot
1 PhotoTags: None
-
another rule shot. plumb
1 PhotoTags: None
-
rule should be plumb up and down when on center
1 PhotoTags: None
-
using steel rule to find center of the shaft. use a point and push it against the rule. if it leans left at the top its too low. leans right at the top its too high.
1 PhotoTags: None
-
milling block
1 PhotoTags: None
-
milling block 3
1 PhotoTags: None
-
this is what the angle plate was designed for to make these parts.
1 PhotoTags: None
-
milling block. using collet chuck to hold small end mill cutter
1 PhotoTags: None
-
slot for carriage bolt
1 PhotoTags: None
-
first slot done. The ends of the slot were pre drilled to line up the cutter then the part clamped for the cut.
1 PhotoTags: None
-
number 3 MT end mill holder. Goes thru the spindle and had a nut on the other end.
1 PhotoTags: None
-
compound removed and angle plate put in its place
1 PhotoTags: None
-
angle plate to hold part
1 PhotoTags: None
-
Lathe milling.
I can use my mill but just want to show others how to do it if they only have a lathe..14 PhotosTags: None