5 results in 0.0106 seconds.
-
Trailblazer 44d no arc
Looking at buying a trailblazer 44d off of a guy but went to look at the machine and it had appropriate power to all the outlets but nothing (no voltage reading st all) at the output post for the torch. Thought i was going to get a good deal but i dont want to buy a money pit. Any ideas on what this... -
Trailblazer 44d no arc
Looking at buying a trailblazer 44d off of a guy but went to look at the machine and it had appropriate power to all the outlets but nothing (no voltage reading st all) at the output post for the torch. Thought i was going to get a good deal but i dont want to buy a money pit. Any ideas on what this... -
Roughneck 2e no weld or power
I recently aquired a 1977 roughneck 2e. have the engine running fair right now, but all at once it quit putting out power. I cleaned the slip rings and brushes to no avail, and discovered I have no power at the brushes. If I jump a wire from the battery to the + brush I get about 20v at the outlet.... -
bluestar 2e
Hello . My welder welded fine then outta blue it just barely cracked an arc or made power I saw,in parts manual just above the #28 resistor ,a solid wire under a cloth sheath it had a small burn mark so I looked all I found was a piece of black plastic and the wirecwas disconected. I got a rectifier... -
XMT-300 turns on but will not hold an arc to weld
Help i need some advice. My new old 300 turns on all relays kick in and you can see plenty of amperage when you try to weld. The problem is that after the starter arc the machine seems to lose power. the arc wont carry and there is no welding when stick welding. I haven't tried tig yet mainly because...
