Announcement

Collapse
No announcement yet.

Search Result

Collapse
7 results in 0.0071 seconds.
Keywords
Members
Tags
bobcat x
  •  

  • Can I safely power a Syncrowave 200 from either a Bobcat or Trailblazer?

    Howdy all.
    I am a complete rookie here so go easy please. I am retired, and only a hobbiest, and I do the odd job for neighbors and friends now and again. I also have done some small paying jobs as well, and I do have my AWS D1.1. I have a Syncrowave 200, Millermatic 211 w/ Spoolmate 150, and...
    See more | Go to post

  • madmikebolla
    started a topic bobcat 225g ser#KD348138 518HRS

    bobcat 225g ser#KD348138 518HRS

    hello everyone I recently purchased a 225g and a s32p12 seems to weld good in cc mode but cv is very weak. I did a open voltage test and found at o % on fine control it runs 11.41 at 100% it only jumps to 14.12 not near hot enough for good mig welds. any help and pointers would be greatly apprecia...
    See more | Go to post

  • brett.campbell
    started a topic warning light on hour meter

    warning light on hour meter

    My bobcat 225 will not start...red light on hour meter comes on inside of the yellow triangle on the meter. Meter shows total hours when switched to "idle" and then -99.9 when switched to "run"...no spark when switched to "start".

    Local tech says it could...
    See more | Go to post

  • ethandg
    started a topic about ready to pull my hair out!!

    about ready to pull my hair out!!

    ok, I bought a miller bobcat 225g with a onan p216g. I had always wondered why it puked out oil out of the fuel pump. needless to say i found out what was causing it. I found that I had 2 bent intake valves and lost the seat in on of them and as of right now the engine is FUBAR'D as of right now. So...
    See more | Go to post
    Last edited by ethandg; 01-31-2014, 05:19 PM.

  • Miller Bobcat 250 Diesel 907213 Should I buy it?

    I am looking at a Miller Bobcat 250 Diesel 907213 with less than 60 hours on machine. What is the difference between this one & the new one 907565001? Are there any known problems with these machines? They are asking what I can purchase a new 250 efi for. This machine will sit unused for months...
    See more | Go to post

  • northernboy1
    started a topic Miller Bobcat 225 Welder

    Miller Bobcat 225 Welder

    Hey all,
    I need to replace the engine in my Miller Bobcat 225 welder in one of my service trucks. It has the ch23 Kohler command v-twin engine in it and I have a new one awaiting the solution to my problem.

    The problem I am having is that I can't (or more like don't know how to)...
    See more | Go to post
    Last edited by northernboy1; 11-20-2013, 03:52 PM.

  • trouble with bobcat225g and 8vs feeder

    Hello everyone....I was wondering if anyone out there uses a bobcat 225g with a wirefeeder. I have a 8vs and tried it on 3/16 plate but could not get any penitration...had it set to cv using .035 wire...should I try smaller wire? any sugestions would be apreciated..thank you
    See more | Go to post
Working...
X