7 results in 0.0053 seconds.
-
If John could pin point what is wrong I would consider sending it to him. I’m debating if I just want to replace it with a dynasty 210 dx since they are around $4,000 new. I don’t want to spend $3,000 for a repair with no warranty.... -
I did look over the other connection while I was in there. Didn’t see any problems. I only use the welder for hobby so it’s a big loss with only 35 hrs of weld time on it. I was hoping maybe someone had this problem before and could pin point which board to replace. This is one of the original versions...Leave a comment:
-
Leave a comment:
-
They had me unplug RC200 and RC210. They come off the black plastic box in the back lower right side. (Water cooler control board) That did not make any difference....Leave a comment:
-
Yes I have but I don’t know what I’m looking at. The Miller Tech had me unplug the board for the water cooler but it didn’t change anything. Still had the same fault pop up....Leave a comment:
-
1.4.1 is pc1 issue and 1.5.1 is cooler power supply failure.
The cooler works like it should. No issues. I’ve unplugged the cooler from the welder and put it in stick mode and tried it. Still comes up cool pwr and shuts the welder down. I’ve even turned the cooler off in the settings....Leave a comment:
-
Dynasty 280DX troubleshooting
Has anyone had to replace circuit boards in their Dynasty 280DX? I have 35 hrs on mine and it is out of warranty. I took it to get repaired and they want $3,000 to “attempt” to fix it with no guarantees. It will turn on and weld for about 30 seconds but it keeps saying “cool pwr, see OM” I can...
Leave a comment: