Part no longer available

[FullScale]

Thanks, I'll give it a try. Fingers crossed, would be handy to know the wire speed.

[FullScale]

I'm currently trying to locate a meter kit, #193 273, for my Miller push pull rig. I've contacted miller and was informed that it was no longer available. Does anyone have any suggestions on where I could possibly find this part? Controller number LC112231. Thanks

[FullScale]

Been using an older MM 250 and a spool gun for the aluminum.

[FullScale]

Steel, Aluminum and Stainless. Just never used pulse before, just look for a starting place to get a feel for it.

[FullScale]

Thanks, 10 degrees will help, sucks getting old.

[FullScale]

I’m new to pulse and not real sure where to start or what to look for. Thought I’d down load the 350P chart and try those settings with my XMT 350 CC/CV and S-64M feeder. Any advice would be greatly appreciated....

[FullScale]

May be a dumb question, but can the XMT 350 CC/CV be mounted and operated at an angle along its long axis, provided the air flow clearances are maintained. Building a mobile boom rig and would prefer not to have to swat down to read or change settings....

[FullScale]

Problem solved. With a data card I was able to set security lock to off. I now can set all parameters. Fortunately access code was off

[FullScale]

Could someone please tell me the 2 buttons to hold down to enter setup, mode and parameter select?

[FullScale]

I tried the instructions in section 10-1. Hold both buttons down while turning unit on. I thought it was referring to the mode and parameter buttons, but no change.I never got Setup in the main display as in step 3 So I tried every combination on the unit. The only combo that came up with something...

[FullScale]

Having trouble resetting my, new to me, S-64 M feeder. I have tried every combination of button holding while powering on possible. HELP, stuck at Program 1 which is lock at a IPM of 240-260.

[FullScale]

Thanks

Thanks everyone, after looking hard and long at my options and budget I'm going with a used WP-20 that I found. Now its time to start looking at coolers.

[FullScale]

I recently bought a new to me Syncrowave 200 and wish to up grade the WP-17 I'm using now. Any help in this area would be greatly appreciated. Most of the work would be on 11 ga. aluminum.