econotig post flow problem

[welder57]

how bout a wine rack?...

[welder57]

thnx...

[welder57]

didn't realize that was what you do for a living. never got that in depth reading some of your other posts. it seems as if a lot of people post problems without the proper amount of info so patience would be a virtue. thanks for the info. i have a gas valve on order. the chip appears ok because i go...

[welder57]

got the response i figured i'd get. my point was there was a better way for him to ask for serial number than how he did. i was using a little sarcasm. i totally agree that he might need some morei nfo. i know people give advice for free as i have a few times. a little politeness goes a long way. t...

[welder57]

you guys up north always so rude. its an econotig CE serial #KH488250. the part number is 125785 but has been replaced by miller with a kit number 222837. is that enough or would u like the names of my children and s/s number-geez have a nice day

[welder57]

i have a miller econotig ce and when i let off the foot pedal the gas continues to flow. there is no adjustment of post flow but its a pre-determined setting at the factory i believe. now i'm no trouble shooter but i removed the gas valve and you can blow thru it. wouldn't it be closed without current...

[welder57]

any of you guys heard of peening the weld after?-read somewhere and can't remember-hate to say it, might have been lincoln's website

[welder57]

had a hobart helmet that went bad- the lens looked like water on one half-the boys @ hahn welding asked me if i left it in my cold truck every night(wife and daughter take up both garage bays) and i said yes-apparently not too healthy for them-it was a auto darkening model(not sure of the model #) so...

[welder57]

i've got the wire stuck to the tip a few times so i need to watch that a little closer. thanks for the tip- if the nozzles aren't too expensive, i'll purchase the 3 and try them. probably won't run flux-core thru this machine as i have my lincoln set up for that. thanks again

[welder57]

just piked up a 251 millermatic-awesome machine. my question is i need a new nozzle but the manual shows 5 different ones. some flush, some recessed, one even called stickout-how do i determine which one i need. the 251 has a miller m-25 gun

[welder57]

nice looking shop, however is that a wood floor i saw??

[welder57]

i too have a lincoln powewr mig `180-guess where thats assemble-thats right, MEXICO
make sure you check-i never would have thought that from lincoln. not sure about smaller millers. i guarantee my trailblazer 301D is made all state side

[welder57]

the pipe u are referring to is carbon steel while most of your fittings from hardware store would be malleable, not worth welding

[welder57]

whats up with u bud bashers-served me well for 35+ years. i'm currently expanding my horizons though-blue moon ring a bell?

[welder57]

i was doing alright until i had to turn my head sideways to view that 1 pic-no, just kidding. nice job. all with a miller suitcase mig welder?-the 8 model or 12!