Search Result

[davido30093]

What type of plug did you put on it? What type of outlet are you plugging it in to?

[davido30093]

30 amps is not enough for that welder on higher settings. Check your owner's manual for the correct wire size and breaker size. DO NOT just install a larger breaker.

[davido30093]

Surge suppressor



YES.

You should always have surge suppressors on all sensitive electronic equipment, but it has nothing to do with your welder.

The HF interference from a tig welder will NOT be blocked by a surge suppressor....

[davido30093]

OxyAcetylene Safety

Here is a good safety video. There is a black screen for about 15 or 20 seconds at the beginning. Be patient, it will start.

https://www.youtube.com/watch?v=O_BEF6myVN4

[davido30093]

Willie, I can understand your rant and there are certainly some valid problems stated; however, I don't believe that it is quite as bad as you seem to think.



For the majority of my life the standard was 115/230. I do remember when it was 110/220. I guess that I am a...

[davido30093]

Willie, I can understand your rant and there are certainly some valid problems stated; however, I don't believe that it is quite as bad as you seem to think.



For the majority of my life the standard was 115/230. I do remember when it was 110/220. I guess that I am a...

[davido30093]

Try turning the amperage down about 10 to 15 amps when using the 6011 vs 7018.

[davido30093]

http://www.youtube.com/watch?v=kblmdScflQU

[davido30093]

Thanks gouch95 and duaneb55. Great info.

[davido30093]

Just note that you will not be able to run it at anywhere near full power off of that 30 amp dryer outlet. I don't think that you are going to have much luck plugging that recommended 6-50 P plug into that outlet either. Match the plug to the outlet and run at reduced power and you will be OK until...

[davido30093]

http://store.caig.com/s.nl/ctype.KB/...1977/KB.215/.f

[davido30093]

Musta been a joke, unless he asked SS to SS or SS to metal, which, of course, would be different rods. Maybe just a communications mix up.

[davido30093]

Here is Lincoln's explanation:

http://www.lincolnelectric.com/en-us...ge-output.aspx

[davido30093]

At about 1 1/2 minutes in on this video, it shows the 252i as the new Tweco 252i as the parent company has made some changes. You might find it interesting.

http://www.weldingtipsandtricks.com/...ghts-2013.html

[davido30093]

In general, on a small trailer like you are building, you need a minimum of four feet between the front of the trailer and the front of the hitch.