Bernard Q300 MIG gun

[kdavis]

Thank you--I will look into to that. I did not know they made one. Thanks again

[kdavis]

Hello again, I was getting my 12rc wire feeder set up last night and came up with a couple of questions.

The feeder came with .045 drive rolls so I assume the liner is is for the .045 wire.
I ordered extra-.035 drive rolls for flux-core wire.

1. Can I run .035...

[kdavis]

Thanks for all the advise, I will just keep the battery tender hooked up and wait out this cold spell. I will probably have to hook up the bigger battery charger to get it charged back up when it warms up. Thanks again

[kdavis]

I have read alot of information on using Isopropyl Alcohol mixed in with the gas on engine driven carburated welders to prevent carb icing. But I cannot find any info on the mixing ratio---per gallon of gas. Does anyone have this info? Is it safe to run this with your gas? I already have Sta-Bil fuel...

[kdavis]

Does Miller still make the Renegade 180? I am trying to sell mine but not having much luck. I listed it at 1,650.00 starting price and had no luck on EBAY. It's two years old and in excellent condition.

[kdavis]

Thanks for all the help--I cant wait to get it started up and going--just got my 12RC feeder in today. I am anxious to get it going. I have not even had time to fuel it up yet, waiting for my days off. Thanks again!

[kdavis]

Hello, I just got my new Trailblazer 302 in and had a few questions about it.
They set it on my trailer with the fiberglass skid it comes with-any suggestions on lifting it to put it back down on the skid I built--rent a lift ect...

I have not put gas in it yet--is it a good idea...

[kdavis]

Thanks for all the help!!!!

[kdavis]

Disregard that, I will pull up the manual on thier website, thanks for your help. I appreciate it very much.

[kdavis]

I was thinking of building a skid as well, do you have the diagram miller has in thier manual or know where I can access it prior to buying the machine?

[kdavis]

Thank you-I appreciate your help

[kdavis]

Hello, I am about to purchase a Miller Trailblazer 302. I have a tandem axle 6x12 flatbed trailer I want to mount it to. Do I need to build any supports for this in addition to the wood floors it already has?

Also what location on the trailer is recommended? Any tips you can give me would...

[kdavis]

Thanks for all the help, I will take a closer look at it tomorrow.

[kdavis]

Thank you I will check for leaks around the torch handle and tip. I usually set it at 25 & 5 maybe I need to go up a bit on the acetylene.

[kdavis]

Hello, I was hoping someone could give me some help on diagnosing an issue with my Oxy/Acet set up. It has worked fine up until recently. I am getting a seperation between the tip and flame when starting it up. Once I get the flame adjusted for cutting I am getting a constant popping sound. I am not...