Search Result

[big mike]

Argon, CO2, oxygen has more CO2 than is normally recommended for stainless(below 5%)

[big mike]

"Gas is tri-mix."
Argon, CO2, oxygen or helium, argon, CO2?

[big mike]

I'm not sure about the wiring but do you have the correct pot?
Miller uses a 1K and Hobart appears to use a 25K

[big mike]

Do you mean part 212454?

http://miller4less.com/advanced_sear...19&search.y=12

[big mike]

Dud is such a nice word for a 250.......I have always used turd.
200?, awesomeness in a Blue wrapper.

[big mike]

Is the power pin of the mig gun fully seated in the drive housing?

[big mike]

Fix the 30A and use with steel or an S22A or 60 series feeder.

[big mike]

You get new screens with each 7.00 gas lens.

[big mike]

http://miller4less.com/advanced_sear...933c549d7bf544

[big mike]

I know it goes against the grain of this forum but....I would use JB weld(the original not the fast setting).
I have a friend that had a crack in one head on his Chrysler 440 street/strip engine. It cracked just below the center exhaust ports and just above the head bolts(if you know those heads...

[big mike]

If I was a young pup again I would start out doing side jobs and paying cash for everything and as you gain cash flow and business momentum the business will grow.
I have seen too many businesses started out on borrowed money and unless you are very skilled in management or REALLY lucky the snow...

[big mike]

Sounds like either a liner or contact tip issue.

[big mike]

Now WHY would someone do that......slow down in business?...

[big mike]

I'll get you pulse on your machine for 10.00
Section 6.2 in your manual.

[big mike]

I am SOOOOOOOO glad I did not have a mouthful of coffee!...