Search Result

[snoeproe]

The oil you run in your bobcat should be related to the climate your operating the machine in....

[snoeproe]

Been down this road myself. Finding liability insurance to cover you for mobile work can be challenging. Most insurance companies want nothing to do with spark makers. Talk to other folks in your area doing similar work....

[snoeproe]

The synchrowave machines are not machines for mig welding. You won’t like how it welds with solid wire and a CC only machine.

[snoeproe]

I’ve seen that on heavy plate in the past. Slightly rounded edges. We didn’t want that round edge for what we were doing so we cut it off and squared our use edge with the radiagraph track cutter....

[snoeproe]

Pretty sure the fine amp control dial needs to be cranked up to get the auxiliary power hertz up?

[snoeproe]

Ceriated tungsten is orange band usually near me. Pure tungsten will ball like that on its own.
which size tungsten are you using? Ensure it’s the proper size for the amperage your running. Ensure your polarity is correct, DC - for ferrous metals and ac for aluminum. Ensure your gas flow is...

[snoeproe]

Or, you can sell it and pick up a 12Rc or a 12vs Miller feeder, plug in and go...

[snoeproe]

I suspect, yes.
What does your manual say?

[snoeproe]

Dont quote me on this but I don’t think so. A 12rc feeder would be an easier fit for you....

[snoeproe]

Which engine is in your machine?
I have many hours on an older BB400. It only had an oil pan heater for a winter heater because of the air cooled Deutz engine. They also have glow plugs on them.

[snoeproe]

Engine is a Kholer. You can see it on the air filter cover.
You never know with these units until
you go check them out....

[snoeproe]

Defiantly a 6011 downhill weld....

[snoeproe]

There’s no keeping the heat in in winter and removing the smoke unless you get a commercial air filtration unit installed. That isn’t going to be cheap.
Why not weld outside?...

[snoeproe]

I had a bluestar 2E. A few years older than that style. Same operating panel. I miss that machine. Welded great and was low cost. Mine had a 16hp Tecumseh gas motor.
Sold mine a few years ago for $800 with factory cover and home made wheel cart, still in very good condition

[snoeproe]

https://www.millerwelds.com/-/media/...front-open.jpg
This is a photo of the new 260. Your panel should be identical. Notice the white breaker switch under the 50 amp power plug....