AEAD 200LE 60 hz GENNY/ WELDER

[g6ypk]

Aead 200-le

Hi there. I had a Miller AEAD 200LE also, but the engine died when the switch ,S1, was put in the power position. It is fitted with a wonderful engine that cranks over first time. I have decided that I cannot figure out what is wrong with the generator.

This...

[g6ypk]

By the way...

I have met the REAL Buz Aldrin. We email every few months, since 1995.
Antony

[g6ypk]

Aead 200le

Hi Buz, I have the same machine. Mine will weld weakly but stops the engine when S1 is set to the power side from weld. In my case, I suspect the windings on the stator to the power are short circuit.

If your engine starts and there is nothing at all, you might...

[g6ypk]

Broken wire 34

Hi there, cruizer. Thanks for the reply. By the way, I have found that the wire (34) goes to a lone spring operated switch via a diode. The switch is not S1 as I suspected the wire might have gone to, and I have no further details to give you, sorry.

The serial...

[g6ypk]

Hi there..

Okay, help... I have a broken wire marked number 34 from the negative terminal of the ignition coil, and the drawing shows that it goes to the Power Weld switch (S1). Should be easy eh... not on your life it is... I cannot see where this wire has come off from, nor...

[g6ypk]

Broken wire # 34 aead 200le

Hi there.... For some reason I cannot post a new thread? Yes, I'm logged in, but heck... I'm brain dead or what, ha!

Okay, help... I have a broken wire marked number 34 from the negative terminal of the ignition coil, and the drawing shows that...