225 Bobcat

[digr]

Are your wooden wheels beveled for going around curves? The flange shouldn't ever touch the rail

[digr]

Make a open end trailer with a fold down tongue and a ramp on each end.

[digr]

What I would do is to cut the hold boss out of the old ear and fab a new ear of the same thickness, cut new ear to fit then cut in the the old boss with the new bushing in it. Vee the new ear leaving a 1/4" gab to the main body. Put the new pin in and measure the best that you can, tack the new...

[digr]

testing

[digr]

Thanks for the help I found the problem. Heat range switch

[digr]

Nothing on AC .9 volts 70 77

[digr]

Thanks for the help
I get power to the leads when switch is on 17 28 volts
120 power seems fine under heavy load
brushes look good and move freely
70 71 30 volts
70 72 70 volts

[digr]

La141736

[digr]

[digr]

225 Bobcat has 120 power but nothing to the welding leads. I was told that it slowly kept loosing power. Any ideas of what to look for. The fuse is good and has a new fine adjustment rheostat in it. The exciter brushes check out OK. There is what to me looks like a diode on top that doesn't show continuity...

[digr]

LOL you gota do what ya gotta do! That is the very definition of a bas tard key! Good job.

[digr]

I am always nervous when I look at a post like this about what I will see but in your case you did a A++ job, well done.

[digr]

No need to weld the bottom, problem solved

[digr]

If it works good down low then the other end would work good up high.

[digr]

take your gun apart maybe you micro switch is stuck closed, has happened to me