Powcon pulser question

[boattrash]

You are kidding right? Monopoly, cheese and tupperware on the same page as your sig????

[boattrash]

did you buy it? went for 128 bucks...

[boattrash]

Cant find any info on the rc250p pulser control. One on ebay now and wonder if it would connect to my 300sm. Price is low enough that cant lose much and it could be pretty handy if it worked. My process would be pulsed mig. Saturday so Arc products cant help....

[boattrash]

It does but at reduced output. will go to 375 on 3phase or 200 on single.

[boattrash]

If three phase is available then I would jump on it in a hearbeat. I had one of those big bullet welders, 600a and it was amazing. Sounded like a turbine when running and had a wonderful arc. I wish I had 3 phase now for my powcon. Anyone run a powcon on a rotary converter?

[boattrash]

Some of my stuff

Here is some of my stuff.



...

[boattrash]

Very nice, I can picture lots of effort to keep it square. My tables have been much simpler and managed to weld in distortion that required straightening.

[boattrash]

look around for a powcon; sm200 often for 300 bucks or less and one of the finest power supplys around.

[boattrash]

That is art, nice work.

[boattrash]

Me thinks that this thread also may have been started by a troll... Can't picture someone really trying for knowledge copping an attitude that quick.

[boattrash]

Yes, mine actually serial numbers to 1985 but all of the above is correct. Onan b48m engine. serial jg021098. Has about 1037 hours. Wont idle down and surges under 1800 rpm no load. Tried loading with heaters and didnt help though I only had two 1500 watt to plug in. Also cant figure out where batt...

[boattrash]

I have a similar unit that wont idle down in weld mode. Solenoid works fine of course but what should I be testing on the idle board? Engine surges as well but welds ok and I get 120 volts out of generator.

[boattrash]

I have built several solid axel trailers using Chrysler K car rear stub axels. They are very easy to use as the bolt on using a flat flange. IMHO small trailers dont need suspension. Built frame of 1.5x3" 1/8 wall tube, doubled the tube where axel welded and inset a backing bar tangent to a frame...