Search Result

[Tailshaft56]

Don't forget you can use a momentary contact control and use the 2T and the 4T settings to adjust amperage. (Ramp up and Down). I'm not sure but I suspect the spot weld mode would be arc on for the adjusted time only and not be able to ramp up or down.

[Tailshaft56]

There was a story on the radio about the Stillwater Ok. plant adding jobs when the Wi plant closes. 2 or 3 days later the story changed to jobs moving to Wi since the Labor dispute was resolved....

[Tailshaft56]

Do you have the control voltage? Most likeky 24 VDC. Check between the relay coil contacts and ground.

[Tailshaft56]

The HF can be set for anywhere that gives you reliable ard starts. HF can cause interference with other electronic devices in the area. If it does you can turn it down till that problem is eliminated as long as your arc starts are good. IE if the wife is complaining Your messing up up her ability...

[Tailshaft56]

For siver soldering you will need a tight fit up. Ther does need to be a few thou clearance so the solder can wick into the joint. Punch marks work well to allow for this. You will also need the proper flux. If you have never hard soldered before it would be wise to practice on some scrap first....

[Tailshaft56]

Keep in mind you should be able to trade up your cylinder @ full value. Let's yoy start out for a few less bucks.

[Tailshaft56]

MY LWS is just the other way. He sells and fills co2 bottles for paintguns as well as selling the guns themselves and accessories.

[Tailshaft56]

Good decision. BTW the 180 is rated for premium beer, not the cheap stuff!!! LOL

[Tailshaft56]

Hard to beat the old 4X6 band saw. no sparks, less moise and they are way more acurate. They are slower.

[Tailshaft56]

When you ask for the S/N tell the seller you need it to download the proper owners manual. True statement.

[Tailshaft56]

Could also be dirt in the liner. Blow it out with air if you have it available.


Dennis

[Tailshaft56]

Sorry to discourage you but when you get a RONCO set it and forget it the instructions tell you that's not quite true. You are right about them making great chicken. As for the Diversion the name pretty much shouts of the market you're shooting for. Had they been out when I bought my TA I might very...

[Tailshaft56]

I can't think of any. Seamless comes from the DOM ( drawn over mandrel ) as opposed to the normal rolled pipe. If you need one tube to fit inside the other that another specialized product. The dimensions are different than standard pipe.

[Tailshaft56]

I second the muratic acid. Spray it on then wash with clean water. Works great in the good ole summertime. Just be quick in getting the water dried off so you dont get a lot of rust.

[Tailshaft56]

Hank I've got a 172. The only way I would put a spool gun on it would be to find the controller used for so cheap a price people would say I stole it. Upgrade is the way to go.