Dialarc HF

[weldslikebutter]

Well I did not want to take the cover off the plasma cutter too soon, hopefully you can see the picture we have the ground clamp wire at 10mm which is rated around 50 amps and we have our 15 to 20 amp- 14 gauged wire that directly hooks to the grounding wire to the circuit board.

See how...

[weldslikebutter]

I just got a Miller foot controller, I was one of those bidders Now I was talking to an electrician, I'm in Canada, trying to get good used machine is hard to come by, delivered. The electrician has estimated the job at $1200.00 that is including the plasma cutter wiring etc.

The plasma...

[weldslikebutter]

Yes that is correct "2 100AMP " levers on a 2-pole breaker that are connected together, is that double pull single throw breaker? Now some are saying they run from 50 amp breaker through a 50 amp plug, others are saying the machine uses up to 70 amps or run there machine on 70 AMP breaker...

[weldslikebutter]

Yes of coarse I'm going to need an electrician, I'm just trying to understand what does the electrician need to hook up the welder and lean about the circuit required for it, in doing so you can than relate to how the welder functions in setting the machines out put etc.. This way I can also provide...

[weldslikebutter]

I'm buying one and I tried the serial no# JH315449 but it return unknown does any one have manual reference for it and the year?
and also what type foot pedal it requires in model or pins. or is there a kit package for it. Also for a house hook up if I ran a 150 amp fuse box in the Garage from...