No announcement yet.

User Profile


Profile Sidebar

Junior Member
Last Activity: 12-12-2019, 11:30 PM
Joined: 11-30-2019
Location: Wisconsin
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • The people in that other thread seem to be talking about using the Miller's battery to jump start another vehicle, or for the welding machine to receive jump starting assistance. I'm talking about using the welding leads in CV mode, at around 14 volts, connected to the target vehicle.
    See more | Go to post

    Leave a comment:

  • elkvis
    started a topic Miller Trailblazer 251 Start Assist

    Miller Trailblazer 251 Start Assist

    I have a 1997 Trailblazer 251, which, as I'm sure most of you know, has CV mode for wire feed. My question is can I use my machine in CV mode to charge and/or jump-start a car? I saw that the newer machines are able to do that. It'd take some care to not over-volt the target vehicle, but I can't think...
    See more | Go to post

  • elkvis
    replied to Trailblazer 251
    I'm sure I could make something, but space is limited inside the cover of the machine, and if there was already something available on the market, I'd rather just spend the money, if it wasn't ridiculous.
    See more | Go to post

    Leave a comment:

  • elkvis
    started a topic Trailblazer 251

    Trailblazer 251

    I recently acquired a 1997 Trailblazer 251 with only 880 hours, and it came with 100-foot leads, a TIG torch w/torch-mounted current control, and a Thermal Arc Porta-Feed 17a wire feeder. I had to replace the stick electrode holder and the LC-10 plug that was on the work clamp, but otherwise, this...
    See more | Go to post
No activity results to display
Show More