Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Avatar
Bill Austin
Junior Member
Last Activity: 05-21-2020, 08:04 PM
Joined: 03-09-2014
Location: Saint Marys, GA
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • Bill Austin
    replied to Syncrowave 250DX Issue
    Continued troubleshooting the 250DX today. Connected a SMAW stinger to the machine and selected the appropriate mode. No output on AC or DCRP. Error code was HLP 11. Miller says the 5 volts being routed through the process switch is not being recognized by the control board and the problem is in the...
    See more | Go to post

    Leave a comment:


  • Bill Austin
    replied to Syncrowave 250DX Issue
    I also wanted to add that I did a power on reset on the machine and there are no error codes displayed when I weld with AC and the machine malfunctions.
    See more | Go to post

    Leave a comment:


  • Bill Austin
    replied to Syncrowave 250DX Issue
    Sorry Guys, my bad, I’m running the machine in GTAW and I’m on DCSP. The machine welds steel in GTAW just fine. The issue occurs in AC. I don’t use this machine for SMAW. The serial number of the machine is LJ190036L. Appreciate your help....
    See more | Go to post

    Leave a comment:


  • Bill Austin
    started a topic Syncrowave 250DX Issue

    Syncrowave 250DX Issue

    My 250DX Weld’s fine on DCRP. When I switch to AC for aluminum, then depress the foot peddle down, the machine appears to go into full power and blows a hole in the material and vaporizes the tungsten. The machine was made in 2008. Has any else experienced a similar issue and what was causing the...
    See more | Go to post
No activity results to display
Show More
Working...
X