Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Avatar
DATEC
Senior Member
Last Activity: 09-23-2021, 05:46 PM
Joined: 08-04-2013
Location:
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • DATEC
    replied to Mm211
    Yep out of warranty, which is my fault. I wanted to give it every chance I could and taking it back to the dealer is a 1.25hr one way drive on a Saturday which I either had no time for or just didn't feel I wanted to ruin my day off doing only to leave it and do it all over again on another Saturday....
    See more | Go to post

    Leave a comment:


  • DATEC
    replied to Mm211
    The Inweld wire is .023 also have .024, .030 and .035....
    See more | Go to post

    Leave a comment:


  • DATEC
    replied to Mm211
    The metal thickness I deal with most of the time is anywhere between 24-18ga. I measured them too to see what's going on and just shake my head in frustration.
    See more | Go to post

    Leave a comment:


  • DATEC
    replied to Mm211
    When welding heavier metal yes this unit welds nice and IMO is way more powerful then advertised, I tested it on 3/8 steel and with it turned up it would blow holes thru it I would have to turn it down to get nice consistent welds. On lighter steel it is inconsistent and very touchy to the point where...
    See more | Go to post
    Last edited by DATEC; 09-04-2021, 08:12 AM.

    Leave a comment:


  • DATEC
    started a topic Mm211

    Mm211

    I have had this mm211 for a while now and can tell you that this unit is a total piece of CRAP. I use it mainly for doing autobody and it causes so much extra work it's not even funny. It either blows the crap out of the metal or welds look like total dog s&@t mounds of extreme rookie blobs. I have...
    See more | Go to post
No activity results to display
Show More
Working...
X