Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
ASKANDY
ASKANDY
Super Moderator
Last Activity: 10-14-2021, 09:00 PM
Joined: 09-03-2002
Location:
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • ASKANDY
    replied to Aluminium tig problems
    If you have a multimeter, you could check a couple things.
    What is the "open circuit voltage"? This is checked with the HF switch in OFF. Put your leads across the output studs and step on the pedal.
    That machine should have digital meters. Make sure the voltage on the multimeter...
    See more | Go to post

    Leave a comment:


  • ASKANDY
    replied to Wire not feeding right
    LOL
    I troll here once in awhile!:-)
    Been covered up doing content development but still love the forum!...
    See more | Go to post

    Leave a comment:


  • ASKANDY
    replied to Electrical Question
    For most home garages I'd say use it on single phase 50 or 60 amp. Just drop the red lead in the power cord. The white & black will be your hot 240 volt and the green will be ground.
    See more | Go to post

    Leave a comment:


  • ASKANDY
    replied to Wire not feeding right
    Release the drove roll tension lever.
    Pull the wire through the gun manually from the tip. If you encounter resistance you may have a bad roll of wire.
    Check the wire roll to make sure the wire is spooling off the TOP row. A lot of times these spools are wound wrong and the wire will start...
    See more | Go to post

    Leave a comment:

No activity results to display
Show More
Working...
X