Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Avatar
JCFab
Junior Member
Last Activity: 07-19-2021, 04:07 PM
Joined: 12-11-2007
Location: Celina, Tx
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • JCFab
    replied to 255 multi and 90/10 gas
    Our LWS only has 90/10 in 300 size bottles. I've used 80/20 for spray quite a bit. It should work on your multi with perhaps some arc length adjustments.

    75/25 works fine for short circuit and I believe there are settings for it inside the cover.
    See more | Go to post
    Last edited by JCFab; 07-19-2021, 07:35 AM.

    Leave a comment:


  • JCFab
    replied to How to Setup Pulse on MM255
    It is VIKING .035" ER70 S-6. Made in Vietnam. Just over $2.00/Lb. We've run almost #100 of it in pulse with all the above problems. The monumental difference with the L-56 left my head spinning.

    I spent a good amount of time badmouthing the MM255 here. I felt I owed an apology to Miller....
    See more | Go to post
    Last edited by JCFab; 07-19-2021, 07:17 AM.

    Leave a comment:


  • JCFab
    replied to Coolant for a tig welder
    [QUOTE=G-ManBart;n616077]

    Evidently not

    You do realize the post before yours was 14 years ago, right?

    I do!
    I finally pulled the trigger and bought a chiller. Decided to check into the magic juice for it. There is so much conflicting information, distilled...
    See more | Go to post

    Leave a comment:


  • JCFab
    replied to Coolant for a tig welder
    Miller ServiceDude,

    You stated "The most important thing about the coolant for Tig is that it is not conductive, if it is it will rob HF away from getting to the end of the torch. RV coolant is conductive. Automotive anti-freeze is not only conductive but the additives in it will attack...
    See more | Go to post

    Leave a comment:


  • JCFab
    replied to How to Setup Pulse on MM255
    A VICTORY!!! The MM255 works pretty well after all!

    So after fighting with this and another MM255 for seven months, Miller did get back with me and suggested turning up the "Arc Control" setting a few points. Factory setting is 30 so I went up to 35. There was minimal improvement...
    See more | Go to post

    Leave a comment:

No activity results to display
Show More
Working...
X