Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Avatar
ccawgc
Senior Member
Last Activity: 11-14-2020, 12:55 AM
Joined: 03-19-2010
Location: Ceres, California
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • jjohn76
    jjohn76 posted a Visitor Message for ccawgc
    CCAWG, do you ever do work on Lincolns? I have a Powerwave 355 that I am looking to find a 355M to upgrade it.
    Thank you,
    Jon
    See more | Go to post

  • had one do some thing like that and it turned out to be the front panel pcb. now very pricey. you will need a loan to buy one they are almost $3000.
    See more | Go to post

    Leave a comment:


  • ccawgc
    replied to Miller 252 Adjustment
    Turn slow, if they work correctly when turned slow they are ok. if they jump around wen turned fast they are ok. the encoders do not work well at high speed. If they jump around at slow speed try blowing them clean. if still jumping the UI/ display will have to be replaced. also they will jump if you...
    See more | Go to post

    Leave a comment:


  • From command ground the 4 wire to the lem should read +15 and -15 and 0 and 0 the minus might read -14.4.
    If different unplug lem and retest pc1 supply to LEM if voltage jumps up Lem is bad. if it stays low then pc1 is damaged. might also
    have something else pulling the voltage down. if...
    See more | Go to post

    Leave a comment:


  • ccawgc
    replied to cp-302
    Get your flash light and magnifying glass. take the right side off and and look at the two relays in the plastic boxes.
    Pull gun trigger, wire should feed and both relays should pull in. light should go out.
    You are going to inspect the relays and look at the wire connection to the relay...
    See more | Go to post

    Leave a comment:


  • ccawgc
    replied to Synchrowave 200 ..HELP-12
    help 11 is when polarity switch is not set right.
    If the welder is in DC TIG and you are pressing the dig button it will display a help 12. Dig and Balance are not used in DC tig.
    Dig is stick and Balance is AC TIG. Also if you are in stick with output on and try to switch to TIG with out...
    See more | Go to post

    Leave a comment:


  • ccawgc
    replied to Millermatic 252 Cuts out
    If after you turn the spot timer off and it keeps coming back on and you know you didn't turn it on. You will need to have the control pcb replaced.
    Or just keep going in and turning it back off. There is a known problem with some of the older pcbs. The pcb will set a spot time when weldr is powered...
    See more | Go to post

    Leave a comment:

No activity results to display
Show More
Working...
X