Shop Tray

[Darmik]

Here is a shop tray, I built this because I'm tired of always having to run back to my tool box.So now I just load up my tray and away I go.After I started building this another co-worker of mine wanted one so now it's a bit of a game who can add the best accessories but I'm in welding and he is in machanics so I guess we will both end up with pretty good carts.
It's still work in progress though

[Darmik]

Shop Tray

Here's a few more pics of my cart still not done

[youngwelder_154]

Darmik I really the the one with Dimondplate but they all look unbelieveable! good work.

[garth]

those look great. Like the coffee cup holder. thanks for sharing

[Darmik]

A Few more pics

Well I dont think I can add much more to this I am going to try to add a lid holder under the table but it's hard to do this under the radar.However the boss has noticed this hey where did this come from? I dont know

[fun4now]

you should tell the boss you made it to save time wile working, he might have you make a few more to get every one going a lil faster. i cant see hime having a problem with it, it looks like its a great time saver and bosses like that kind of stuff.

[BeZe]

Accessories

If the challenge is to add accessories.
How about a small electric motor and radio control so that it can follow you around the shop

[link523]

i built one cart out of my engine stand the was sitting in the corner collecting dust got a full sheet pan (25*19) made an bracket and bolted it on! if i need the stand just on bolt the tray and bolt up the motor

[Darmik]

Accessories

If the challenge is to add accessories.
How about a small electric motor and radio control so that it can follow you around the shop

Accessories Hey do you work at the same place I do ? that's what the other guy's said yesterday It's fun. I do have one problem though no no not me my cart I need a 1 3/4" OD X 18" Long lose spring because I can pin it at 4 different heights but right now it's to heavy with all my stuff on it.I would like to push down on the spring and pin in stead.

[fun4now]

get a shock off an old office chair to use for up and down ajustment.
the spring would be too much truble to try to get right.

[Darmik]

Spring

get a shock off an old office chair to use for up and down ajustment.
the spring would be too much truble to try to get right.

Hey fun thanks for the Idea I'll have a look at that

[paulrbrown]

Darmik, I can still see room left for a 'Lazyboy'. Nice job, and great Idea, nothing worse than being 50 feet from the toolbox and needing one more thing. NOw, how about that KEG......Paul

[MetalCrafter]

Hey Darmik,
What kind of truck is that in the backround, could you send a pic?

Well I dont think I can add much more to this I am going to try to add a lid holder under the table but it's hard to do this under the radar.However the boss has noticed this hey where did this come from? I dont know

[Darmik]

Truck in back ground

It''s a GMC 3500 Duramax diesel I have 5 of these to build or customize

[MetalCrafter]

Nice truck I'm currently looking for a GMC chasie. Since you cutomize bodies what do you suggest for me? I am in the mist of taking over my Father's Ironworking buisness, we do anything from railings to structural steel. I'm looking for a truck body that can hold everything I need for outside work. I'm also looking for some type of compartment for the Oxy and Act tanks. The police in NJ pull work truck over all the time and frenzy with the tickets. Please if you have any suggestions please let me know.