Announcement

Collapse
No announcement yet.

syncrowave 250 dx

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • paulrbrown
    replied
    you will need a 100 amp breaker for 220 single phase, I have a synchrowave 250 and know, I rigged for awhile on 2 50's but was told that was not safe, on a 50 and a 40, one would trip. Good Luck, Paul

    Leave a comment:


  • JonnyTIG
    replied
    You can find the info you are looking for in the 'service & support' menu at the top of this page. I run a Dynasty 300 off of 220 and a 50 amp breaker. Mind you, I don't use the machine above 200 amps, but the required breaker for the machine provides 65 amps at 60% duty cycle, using 250 amps welding current. If you have 100 amp service to your shop, than you should have nothing to worry about with the recommened breaker.

    Leave a comment:


  • R DOGG
    replied
    For a 220 welder you will need 200 amp service.

    Leave a comment:


  • Guest's Avatar
    Guest started a topic syncrowave 250 dx

    syncrowave 250 dx

    Im looking to purchase a synchrowave 250 dx and would like to know if 100 amps will be enough to power the machine. I currently have 100 amp service in my garage.
    thanks, Tony
Working...
X