Caster Base for Cutter Grinder

[MAC702]

After the paint dried,...

No wonder it takes you so long to get anything done.

As for contacting a Mod, do you have the ability to flag one of your own posts? If not, just flag mine or MMW's. Then put the details in the message. That will get a message to a Mod. But I can't promise anything actually happens after that.

[Don52]

No wonder it takes you so long to get anything done.

As for contacting a Mod, do you have the ability to flag one of your own posts? If not, just flag mine or MMW's. Then put the details in the message. That will get a message to a Mod. But I can't promise anything actually happens after that.

Thanks, I was able to flag the unapproved post.

-Don

[walker]

Nice work! Milling the bevels for fillet welds is over the top!

[Don52]

Post #8, with pictures 36 - 40 just got approved and posted. Check it out. On this post I show my dual shield settings and pictures of the large spray transfer welds for the large 1/2” plates on the bottom of the base.

-Don

[walker]

when I first saw this I thought’That is one **** of a light fixture!’

[Metjunkie]

when I first saw this I thought’That is one **** of a light fixture!’

That must be an LED light. (Load Elevating Device.)

[Don52]

That must be an LED light. (Load Elevating Device.)

I had the same concern that the ratcheting come along seemed to be attached to the LED light. If you look closely at picture #55 you will notice that I removed the LED for this picture for this reason.

-Don