Announcement

Collapse
No announcement yet.

Fabricobble Hinge

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • tarry99
    replied
    Like Ryan stated..............Cheap........and ready to go.

    Leave a comment:


  • Sberry
    replied
    Several versions of this, can make stock and chop saw it. Add rubber to keep from rattling.
    Attached Files

    Leave a comment:


  • Sberry
    replied
    I have made dozens of hinges. Xxh pipe has the right note for 1/2 and 7/16 will go in 3/8 standard.
    Attached Files
    Last edited by Sberry; 11-30-2018, 03:39 PM.

    Leave a comment:


  • ryanjones2150
    replied
    Precisely.

    Leave a comment:


  • Burnt hands
    replied
    These might be the type Ryan mentioned.

    https://www.guden.com/Item/Stainless...nges/SSWM080FP

    https://www.guden.com/pages/PDF/weld...swm080fp-d.pdf

    Leave a comment:


  • ryanjones2150
    replied
    That would defeat the purpose of buying them for sure.

    Leave a comment:


  • Bob La Londe
    replied
    And then I'd have to cut off those annoying flats. LOL.

    Leave a comment:


  • ryanjones2150
    replied
    The hinge you seek is readily available, usually from your LWS or hardware store, come with its very own bronze bearing washer and the bigger ones have grease fittings. And they're cheap. I keep a few of several sizes in my parts bin.

    Leave a comment:


  • Bob La Londe
    replied
    Easy Answer

    Leave a comment:


  • Bob La Londe
    started a topic Fabricobble Hinge

    Fabricobble Hinge

    So who among you has made a quick and dirty fabricobble hinge like this? What issues did you have? How did you space it so the hinge rounds didn't rub?

    If you have watched many fabrication of cool gadgets videos on YouTube I'm sure you have seen this type of hinge or pivot made. I've done it a couple times, and mostly I've gotten lucky, but on a recent fabrication where I took the time to lay everything out properly the inherent flaws in this method of hinging something bit me and I had to cut it all off and grind it flat again to start over.
Working...
X