Announcement

Collapse
No announcement yet.

Mailbox Post

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • ryanjones2150
    replied
    You're killin me Joe.

    Leave a comment:


  • Tinker Joe 2
    replied
    Ryan, Ok, I will bring your tools back, just wanted to use them a little while, will try to stop that in the future
    Last edited by Tinker Joe 2; 08-20-2017, 05:15 AM.

    Leave a comment:


  • ryanjones2150
    replied
    You were probably poaching tools in my hood again, Joe. Dadgumit.

    Leave a comment:


  • Tinker Joe 2
    replied
    This one they won't run over and if they do they won't get far, 5 1/2" casing 3/8" wall, the mail lady asked how I pushed those wrenches through the pipe, she is sweet so I explained.

    Leave a comment:


  • Don52
    replied
    Originally posted by ryanjones2150 View Post
    Leave it to a local government to just toss stuff like that in the trash. Wasteful. Nice purposing use of it.
    I agree and you should see the wimpy two inch square tube that replaced it.

    Leave a comment:


  • ryanjones2150
    replied
    Leave it to a local government to just toss stuff like that in the trash. Wasteful. Nice purposing use of it.

    Leave a comment:


  • D Auger
    replied
    Nice job

    Leave a comment:


  • Don52
    started a topic Mailbox Post

    Mailbox Post

    Recently the county re-did the traffic lights and widened the road at several of the intersections in town. As a part of the retrofit, they dug up some of the existing posts and discarded them in a dumpster. My customer thought that post that used to have the street crossing button on it would make a nice mailbox post. The Aluminum post is 4-5/8” OD with a ¼” wall, so it is sturdy. I made a plug for hole where the button used to be and welded up a half a dozen tapped holes in the post. I welded two blocks to the horizontal tube, so that my customer can attach a piece of wood to mount the mailbox. I left the horizontal tube open, to be used for newspapers. Even though there is a cast cap on top of the post, I welded a cover over it to minimize moist air getting into the post and condensing. It was a challenge TIG welding on the post because my Dynasty 200 DX welder is a little wimpy for the ¼” wall thickness. The other challenge was that the Aluminum post was heavily oxidized because of the years of exposure to the elements. I cleaned up the area of the post to be welded with a 4-1/2”stainless Steel wire wheel. I used 75% Ar 25% He mixed gas and a little preheat to extend the capacity of my little 200-amp welder.

    -Don

    Pictures:
    1. Pieces all cut up
    2. Tee joint
    3. Block to mount mail box
    4. Mailbox all done
    Attached Files
Working...
X