Announcement
Collapse
No announcement yet.
Pullup rig built last weekend
Collapse
X
-
Pullup rig built last weekend
Built an outdoor pullup bar rig for a friend on Saturday.
Requirements:
Stable enough for a 240lb person to swing around on
Non-permanent(didnt want to set posts in concrete)
8' tall bar
Inspired by these rigs made by Rogue
Below is what I came up with.
Wife testing it out
A few questions:
Ideas to minimize side-to-side sway. When he swings above the bar to do a bar muscle-up(google it), there's some movement to his left/right. Maybe some gussets/angled supports like this?
Any tips on getting accurate cuts for mitered joints? To do fully mitered corners on the triangles, I would have needed ~29 deg cuts. My bandsaw can't make such a steep cut. Had to go with butted joints. Event those cuts were a bit off and required some grinding to get everything to fit before welding it up.
I told my friend to buy some plastic end caps to keep water out of the open tube ends. Think those are water tight? Maybe he can add a bead of silicone.
Thanks,
MichaelTags: None
Leave a comment: