If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
.
Miller Bobcat 225NT onan
Millermatic 211
Spoolmate 100
(Retapped to fit regular mig tips)
Work better & less parts to stock.
Miller 130xp
T/A Dragster 85 (portability 11 pounds)
Oxygen/Acetylene torch set 50'
2. 4-1/2" grinders
1. 9" grinder
14" Makita chop saw
1/2" Aircat impact gun 900#
Good for you, Nice to see work come to a guy when things are slow or times are tough. I know i have been slow the last week or so, very cold where I am so hopefully guys will be breaking stuff ! Best of luck to you on the repair, post some pics when you get it finished.
I have a welding addiction
...the only stupid question is the one you didn't ask
If you haven't fixed this yet (and I know this is a late suggestion) I would call that number of the company and see if you can find out what steel they are using so you can match filler metal. Probably A36,,,,but you never know and it would definitely help with the liability question. Good luck with the project.
I would cut out all of the bad and start over. I also would make the gussets larger and run it down farther to the bottom channel like it isn't in pic 2. Also not to a point at the bottom leave some more meat...Bob
Where the gusset is needed the most there almost isn't any.
Comment