7018 3/32 uphill

[Pipewelder101]

That was some fab I did at work in stands so they look the same all they way around. This job I been stuck with the small bore 2 1/2,3,4 so I jump to go to 8" and 10". You guy would have a good laugh if I posted pics of the welder I use its a old very well used Dial-a-arc that i has a mind of its own. I posted some small bore pic that where done in place.

[Cornerstone]

[ATTACH]29999[/ATTACH]
[ATTACH]30000[/ATTACH]

Very nice indeed. If that's a position weld,how about some pics of the bottom.

[Pipewelder101]

Here is some 1/8" and 3/32" 7018

[beamwalker]

now do it with 1/4" rod

[2tay530]

Looks fantastic! Wish my uphill looked that good

[mild steel sheet]

walker you are really very funny.. 1 2 chha chha chha.. with ha ha ha

[Daniel]

Welds looks good, now for the pictures you need more practice lol.

[moltenmetal]

Nicely done! Much better.

[Cornerstone]

looks good to me. Instead of the foxtrot, you might try a 1, 2, cha cha cha, 3, 4, cha cha cha..,.,

lol.

[beamwalker]

looks pretty good

[walker]

Looks good to me. Instead of the foxtrot, you might try a 1, 2, cha cha cha, 3, 4, cha cha cha..,.,

[wayne50]

Wish I could do as well.

[Diddle]

thanks for the help

thanks for the help I like that 1-2-3- count I had some time today to try it out

[jazond82]

Watch The crater fill it will become brighter then move And you can see The flux moving toward The puddle And change sides when it gets about an 1/8 awau

[beamwalker]

pause long enough til you see the flux run down towards center. for example if you are on right side of weld you will see the flux kind of roll down towards the left then move left until the flux moves towards the right. dont know how to explain it any better. if you are in east tn i can show you on tb302