Announcement

Collapse
No announcement yet.

Pony pipe clamp storage

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • BD1
    started a topic Pony pipe clamp storage

    Pony pipe clamp storage

    hi, could never decide on how I wanted to store the 3/4" pony pipe clamps. Used a recycled piece of 4" pipe with flange, weld plate to inside flange bottom, Dropped 3/4" threaded rod into flange holes and weld, cut 1/4"x2" flat stock 3/4" wide and welded to 1" pipe coupling and then weld to 4" pipe. With inside plate on bottom I store my bar clamps inside the 4" pipe.I should have done this years ago. Takes up very little space and you can spot the length of each clamp.
    Attached Files
    Last edited by BD1; 02-04-2012, 12:12 PM. Reason: remove pictures

  • BD1
    replied
    Thanks. I got quite a few scraps of 4'' with flanges. I made up a spool piece about 36'' face to face on flanges. Then had a 20'' square piece of plate that I
    welded some 5/8'' studs to so they match the flange bolt pattern on center. Now I have a roll about flange to flange table top. Just remove when storing.

    Leave a comment:


  • Great White TJ
    replied
    Nice job, great idea!!!

    Leave a comment:


  • Boomer8404
    replied
    Nice pipe clamp stand, I think I might have to pull a copy cat and build one like it, lol.

    Leave a comment:


  • kevhead63
    replied
    Great idea,looks good.

    Leave a comment:


  • BD1
    replied
    Thanks, you can use the same idea use for storing shovels,rakes,brooms, anything with handle and it fits in corner of garage or shed.

    Leave a comment:


  • fromttt
    replied
    Very nice idea and sure beats leaning the clamps against a wall.

    Leave a comment:


  • strube1369
    replied
    Cool idea. Keeps them handy but not in the way. Nice.

    Leave a comment:


  • aametalmaster
    replied
    That looks like it will work good...Bob

    Leave a comment:

Working...
X