Announcement

Collapse
No announcement yet.

Cat 303C Dozer Edge

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • admweld
    started a topic Cat 303C Dozer Edge

    Cat 303C Dozer Edge

    Couple of pics of a mini excavator dozer edge i did last week for a customer.The edge is 5/8"thk x6"wide 60"long.Mig welded it with .035 70s6 .Preheated a little to slow the cooling.
    Attached Files

  • admweld
    replied
    Originally posted by admcnich View Post
    Very cool, I was refering to the side, I think it was pic #2. It seemed that the edge was a little shorter then the blade on the mini.
    That was so i could layin a nice root pass,with a couple of filler passes.I left about 3/16 on both ends.

    Leave a comment:


  • admcnich
    replied
    blade

    Originally posted by admweld View Post
    This will round over more with wear.The old edge is cut off before installing this one if thats what you are refering too.
    Very cool, I was refering to the side, I think it was pic #2. It seemed that the edge was a little shorter then the blade on the mini.

    Leave a comment:


  • admweld
    replied
    This will round over more with wear.The old edge is cut off before installing this one if thats what you are refering too.
    Last edited by admweld; 01-12-2012, 03:29 PM.

    Leave a comment:


  • admcnich
    replied
    blunt end

    One nice thing with the blade like that, back dragging would be very nice. Never seen a blade like that on the mini's, most seem to round out on the bottom and is left that way. One thing I am wondering, how big of a gap is that between the end of the blade that you installed, and the edge of the mini's blade?

    Leave a comment:


  • admweld
    replied
    Originally posted by chewinggum View Post
    A blade like that is used mostly for pushing and there is no need for a sharp edge.
    CG
    Thank you,exactly.

    Leave a comment:


  • chewinggum
    replied
    A blade like that is used mostly for pushing and there is no need for a sharp edge.
    CG

    Leave a comment:


  • admweld
    replied
    The beveled part is about 1-1/4" so when it wears,which would be quick with the thin part you are now into the the thicker section anyhow.The blade is 3-1/2"below the push board.Do it anyway you like, this is how i,ve done them for 10+ yrs have not had a complaint about it yet.

    Leave a comment:


  • Daniel
    replied
    I think the bevel should be at the bottom as well. All the blade edge I'v done the bevel had to be at the bottom. Maybe the little blades are different.

    Leave a comment:


  • admweld
    replied
    No the thick edge down on this.If i was welding it into a bobcat bucket the the thin edge would be forward.This is weldable bucket lip i use for doing this.
    Last edited by admweld; 01-09-2012, 09:37 AM.

    Leave a comment:


  • metal-doctor
    replied
    Is the beveled edge not supposed to be on the bottom?

    Leave a comment:

Working...
X