If you are like me and have a few bikes one job that comes up often is replacing fork seals.
When you have done this a few times you realise the problem with handling the oil dripping tubes and springs.
The other problem is if you lay them down on the bench there is no room for anything else.
Well today I decided to make a fork dripping stand from a few ali parts.
The problem is clamping two angles together back to back while keeping them at the right angles. Clamp and tack all round.
Ji
When you have done this a few times you realise the problem with handling the oil dripping tubes and springs.
The other problem is if you lay them down on the bench there is no room for anything else.
Well today I decided to make a fork dripping stand from a few ali parts.
The problem is clamping two angles together back to back while keeping them at the right angles. Clamp and tack all round.
Ji
Comment