Need Help with Miller 200LE

[welder_one]

http://www.millerwelds.com/service/locate_om.php


try this, i hope it works, and i hope it helps.

[welder_one]

you can download the owners manual and wiring schematics for your machine from this website. i'll try to post a link on the next post

I am new to this forum, and I need some help.
I just bought a Miller AEAD 200LE ss. # HF832201
It did not have the toggle switch that goes from power to weld.
I look it up and the part number was 035-261, then I found that it has be change to # 011622.
The help I need is what wire go where?
There is 7 wires one wire has 1 jumper wire, switch has 9 post.
The best I can make out numbers on wires is blue #52,all the rest are black #7,#7with jumper,#53,#51,#5,and a number 3 or it might be a 9 can’t read it very good.
I am going try to post pictures..
Any and all help will be APPRECAITE.

Thanks
BigBen