Mm180

[craneops]

I'm curious/confused about the Wire Speed Tracking Mode feature on this machine. The tracking mode on this machine is set to off from the factory. What advantage/disadvantage does it have by having it on? After going through the procedure to turn it on does it stay on, or do you have to do it after each start up? I've read the owners manual a few times and I am still a little confused. Thanks

[Danny]

The unit stays set in whichever mode you set it up for, until you follow the procedure to set it to the other mode. So, if you set it to wire speed tracking on, it stays in this mode until you reprogram it.

[gatkeper1]

Read this post from the Hobart forum an WFST
http://www.hobartwelders.com/weldtal...1&postcount=14