Tweet
20ga Dull Finish Stainless steel that I hit with a 5" blending disc for the design.
-
-
pretty neat. could you link me to the blending disc that you used? -
SST Artwork
Nice looking job.
I did a similar thing with HR angle that I used for a table. I mitered the corners and the top sits down inside. The rest of the base was wrought iron with one inch square twisted legs and scrolls down to the legs. The visible parts of the angle were textured with a grinder, wire brushed and covered with automotive clear coat.Bill
Miller Mig 130XP
Linde VI206 W/Mig
Miller Econotig
L Tec Plasma PCM32i
Pneumtic Forging Hammer 75#
Mechanical Forging Hammer 65#
Propane Forge
Makita Chop Saw
Bader 72" Belt Grinder
Bader Knockoff 72" Belt Grinder
Milwaukee PortobandComment
-
I also made some custom hangers for it so it's less then 1/8" off the wall.Comment
-
Looks nice man.
Miller 211 A.S. and Spoolmate 100
Stickmate LX 235 AC / 160 DC.
Clarke 180 EN Just in case
Spectrum 375 X-Treme.
O/A Medium Radnor Torch, Large Victor Torch.
Milwaukee 14" Chop Saw.
4 x 6 Horizontal Band Saw.
Rockworth 80 Gallon 2 Stage 16 SCFM @ 175 PSI , 15 SCFM @ 90 PSI.
Jackson Passive shade #5 for the plasma.
I almost forgot the Hobart XVP AD Hood.
Projects and Misc Albums
http://picasaweb.google.com/keesfriend Feel Free to Have a Look ( Just keep in mind I am an amateur )Comment
Comment