No announcement yet.

SS Art Work

  • Filter
  • Time
  • Show
Clear All
new posts

  • SS Art Work

    20ga Dull Finish Stainless steel that I hit with a 5" blending disc for the design.
    Attached Files

  • #2
    pretty neat. could you link me to the blending disc that you used?


    • #3


      • #4
        SST Artwork

        Nice looking job.
        I did a similar thing with HR angle that I used for a table. I mitered the corners and the top sits down inside. The rest of the base was wrought iron with one inch square twisted legs and scrolls down to the legs. The visible parts of the angle were textured with a grinder, wire brushed and covered with automotive clear coat.

        Miller Mig 130XP
        Linde VI206 W/Mig
        Miller Econotig
        L Tec Plasma PCM32i
        Pneumtic Forging Hammer 75#
        Mechanical Forging Hammer 65#
        Propane Forge
        Makita Chop Saw
        Bader 72" Belt Grinder
        Bader Knockoff 72" Belt Grinder
        Milwaukee Portoband


        • #5
          I also made some custom hangers for it so it's less then 1/8" off the wall.


          • #6
            Looks nice man.

            Miller 211 A.S. and Spoolmate 100
            Stickmate LX 235 AC / 160 DC.
            Clarke 180 EN Just in case
            Spectrum 375 X-Treme.
            O/A Medium Radnor Torch, Large Victor Torch.
            Milwaukee 14" Chop Saw.
            4 x 6 Horizontal Band Saw.
            Rockworth 80 Gallon 2 Stage 16 SCFM @ 175 PSI , 15 SCFM @ 90 PSI.
            Jackson Passive shade #5 for the plasma.
            I almost forgot the Hobart XVP AD Hood.

            Projects and Misc Albums
   Feel Free to Have a Look ( Just keep in mind I am an amateur )