No announcement yet.

Motorcycle stand project

  • Filter
  • Time
  • Show
Clear All
new posts

  • Motorcycle stand project

    So I'm building this dragbike.

    Since I'm setting it up piece by piece, it was all over the garage and on the floor. Maybe its just me, but I was tired of bending over and working on the floor with the thing unbalanced and falling all over the place.

    The motor will not be done for a while, so I built a stand to do all the bodywork, suspention, and frontend setup. Came out good...
    Attached Files
    Two Dynasty 350's with Wireless pedals
    Victor O/A
    Profax 250 weld positioner
    Bridgeport mill
    Logan Turret lathe
    RMD tubing bender
    Enco vertical saw
    Baileigh Auto cold saw
    IR 80 Gal dual stage compressor
    Misc Fab equipment

  • #2
    hey its simple and it works what else can you ask for.