Small Circle Burner For Torch......

[Vernon]

A Circle Burner For My Victor Torch. Burns 1/2" To 9" Holes Easy To Use I Can Cut Perfect Circle. Can Remove In Min. And Go Back On To Cut Same Size Hole As Before Works Off A Center Point.I wanted Something Lite.I Took A Split Set Collar And Tig It To A Pcs Of Flat Bar Than Milled A Slot Long Ways In The Flat Bar.Than Bent The Rear Up To Fork It Around The Torch. Than Took A Pcs Of 1/4" Round To Make Pivot Point, Threaded For Two Nuts. Than Made Off Setting Leg In 1/4" Pcs. Check The Pic
Vernon

[BC Iron works]

i like that

[Blondie_486]

So do I!!!

[kevin]

very nice work, great idea, from the looks of it i bet the cuts come out perfect

[strube1369]

torch circle cutter

Nice job Dude, looks professional!

[m.k.swelding]

dose it only cut one size hole or can it be set for diffrent sizes

[MMW]

If you look at the second pic it is slotted so you can move the pivot for different size holes & then tighten it with the two nuts. These type of circle burners give a very nice accurate cut. Been using a similar one for years.

[Vernon]

Cirle Burner

dose it only cut one size hole or can it be set for diffrent sizes

--------------------------------------------------------------------------------

A Circle Burner For My Victor Torch. Burns 1/2" To 9" And Everthing In Between By Unlock 1/4" Nuts You Can Slide The Pivot Point Forward And Backwards Or Any Thing Between.

[Vernon]

Thank You

If you look at the second pic it is slotted so you can move the pivot for different size holes & then tighten it with the two nuts. These type of circle burners give a very nice accurate cut. Been using a similar one for years.

I like how you explained it. Vernon

[Vernon]

My Drawling for circle burner

Here is the blue print I made to build the circle burner.

[MMW]

Cool drawing. Did you do that freehand?

[Vernon]

Drawling

Cool drawing. Did you do that freehand?

Yes I used a ruler and a pencil is that freehand! Drawling took about 3 to 4 hours, But made the job faster having it to scale and knowing what I wanted.
Thanks Vernon