If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi Paul!
Nice shop, and good job on the cart. Can I have It? The welding equipment too? and those neeto tables with the built in outlets? and all those wheels on the ground under the drill press? Can I have your drill press too? Har Har Harrrr!!!!!
When I win the Miller shop givaway I will give you all my old welders. Maybe then I can quit my day job. The wheels are going on some recycling bin carts, my latest get rich quick scheme. Thanks everyone for the great comments!
Paul
Hi Paul!
Nice shop, and good job on the cart. Can I have It? The welding equipment too? and those neeto tables with the built in outlets? and all those wheels on the ground under the drill press? Can I have your drill press too? Har Har Harrrr!!!!!
Hello all
I am new to this board. But have been hanging around reading and learning for about a month. I want to thank everyone for the advice and humor they have shared. Welding sometimes takes allot of both, or at least it does for me. I just finished a new welding cart for my MM 130DX and Spectrum 375. The machines sit sideways on the cart like a hand truck. Good for rough terrain and not too bad going up the ramp into the truck. Hope someone can use this design. And I can pay back some of the help I have gotten from reading your posts.
Leave a comment: