Announcement

Collapse
No announcement yet.

Trailblazer 302 house power

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • walleye1
    replied
    Thanks guys, i guess the people at my local northern tool dont even know what they sell! i think both setups would work great! i will check it out

    Leave a comment:


  • SkidSteerSteve
    replied
    We have that very same set up at our office for use with my bobcat 250. We had it wired that way when it was built. We have a manually operated 300amp, Dual Pole, Dual Throw (DPDT), with center off switch from the local electric supply (I think ours is built by either Square D or Cutler-Hammer, can't remember). The load is connected to the center of the switch and then grid power is hooked to one side of the switch and a gen connection on the other side. With the center off, there is no chance of back feeding the grid and causing trouble. If you switch everything, then you would need to have some sort of indicator on the grid side just for the sake of knowing when commercial power is back on line.

    Here's a pic from another thread here on the messag board of our set up.


    SSS
    Last edited by SkidSteerSteve; 08-27-2007, 10:54 PM.

    Leave a comment:


  • shortarc
    replied
    Is this what you are looking for.

    http://www.northerntool.com/webapp/w...6624_200196624

    Leave a comment:


  • walleye1
    replied
    they only have the ones that work with select circuits though, was there tonight, thanks again

    Leave a comment:


  • Anti-GMAW
    replied
    Northern tool and supply.

    Leave a comment:


  • walleye1
    started a topic Trailblazer 302 house power

    Trailblazer 302 house power

    Question, does anyone know where to get a switchover box to hook the generator to the house, i want to totally disconect incoming power and power the whole house with the generator rather than just powering some of the circuits in the box, i realize i wont be able to run every thing at once but dont want to be limited either, thanks for the help!
Working...
X