No announcement yet.

Round corner table top.

  • Filter
  • Time
  • Show
Clear All
new posts

  • Round corner table top.

    I bought an old 1940's SB shaper a while back and it needed a stand. I wanted an old time round corner tray top so i made one from 1/8" steel some 1/8" x 2" flat and some 1/2" round bar. I put the flat bar on a 45* angle then rolled some 1/2" round in my bender for the top edge. Then filled in the corners with 3 pcs of steel and ground it all off after welding. Sort of how i used to do the Little Tykes molds except they were SS...Bob
    Attached Files
    Bob Wright

    Spool Gun conversion. How To Do It. Below.

  • #2
    Looks great, Bob. I like that look. Looks like you put a bit of work into it as well.
    Maxstar 200DX
    Maxstar 300DX
    Dynasty 200DX
    Spectrum 701
    LMSW-52 spot welder