Announcement

Collapse
No announcement yet.

Welding table build

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Broccoli1
    replied
    Pics not working for me??

    Now I can certainly see them
    Last edited by Broccoli1; 11-15-2008, 11:03 PM.

    Leave a comment:


  • Bryan L
    replied



    Last edited by Bryan L; 11-15-2008, 10:54 PM.

    Leave a comment:


  • Bryan L
    replied



    Last edited by Bryan L; 11-15-2008, 10:52 PM.

    Leave a comment:


  • Bryan L
    started a topic Welding table build

    Welding table build

    I have been trying to collect the material to build a table for some time now and finally have all that I needed.
    I thought that I might as well take some pics during the build to share. Now to start with I must say that this table is not intended to be a 100% true worktop.

    Materials:
    4 ~ 31" 2"x2" square tubing (3/16" wall)
    8 ~ 31" 2"x2" angle (3/16" wall)
    4 ~ 4"x4" plate (1/4" thick)
    1 ~ 48" x 48" (1/4" thick)

    I chose to make my table with a base of 35" square for a couple reasons. First is that I wanted adequate overhang of the top plate for clamping.
    The second reason is that I had 12' lengths of 2x2 angle but they were not perfect 12' long and I did not want scraps left over.
    I wont describe every pic and I don't have a drawing. But if requested I am sure it can be arranged.







    I tacked the top plate to the base with 1" welds in two places on each side.
    I am not totally done yet as I will be putting a power bar under the table, A hanger for my grinders and my vise.
    Last edited by Bryan L; 11-15-2008, 10:51 PM.
Working...
X