Automation for 8030 Plasma

[MCRAUTOMATION]

Hello all, I have a miller 8030 that I want to hook up to a CNC Plasma table. I want to know if I can add the Automation option to my 8030. I have a machine torch for the system, but I don't have the box on the back to interface it to my CNC. Any help with this would be appreciated

[fun4now]

if all else fails give miller teck. guys a call. they have always been verry helpfull. if you have a machine torch i'm shore it can be done, might just need a softwhere setting.
good luck.

[Anti-GMAW]

You don't need a plasma table. I'll take it of you'r hands for ya for $10 and even haul it away for free.

[fun4now]

give the motorsports board a try, i know a few guys over there have plasma tables. they have talked about haveing to set the delay times on the cutter's to CNC startup. so they may be of more help.
you will have to re-regester over on the other board again but its well werth it to have access to both boards.
welcome to the site's .