No announcement yet.

New to forum wanted to share some MIG projects

  • Filter
  • Time
  • Show
Clear All
new posts

  • New to forum wanted to share some MIG projects

    I just joined up for some advice on my new-to-me 180SD, thought i would share some of my MIG projects

    Did a 4 1/2' X 8' trailer for my uncle used a stripped down mercury villager rear axle 3300lbs rated!, I swear you could park a tank in this thing frame is 3"x3"x1/8' square tubing! (i think i over designed it a lil)

    My Go-kart for some fun! used a 11hp honda, comet torq-a-verter series 40 primary drive and a #60 chain final drive, hydraulic disc brake mercedes benz caliper and toyota hi-lux clutch master for the brake master. Thing is soo much fun!
    Attached Files
    Last edited by Garage guy chris; 04-11-2008, 02:52 AM.
    Garage Guy Chris
    -Miller matic 210 w/ spoolgun
    -Syncrowave 180SD

  • #2
    Put a little shovel in front of that thing and LET R RIP!!!!!!!!!!
    I'm not late...
    I'm just on Hawaiian Time


    • #3
      Real nice..

      Very cool. Keep the photos coming! And remember as a welder, nothing is overbuilt, unless it won't fall down.

      We depend On:
      Miller | Esab | Lincoln | Fronius
      Baileigh | Drake | Eagle | Knuth
      Victor | Harris | Smith | Bessey
      Snap-On | Hilti | Ingersoll Rand
      Burco/Koco | Onan | BobCat
      Tracker | Infratrol | AmeriCast

      We belong to or support:
      American National Standards Institute
      American Welding Society
      The Welding Institute
      Fabricators & Manufacturing Association Int'l.

      Anderson & Co. LLC
      Metal Cr


      • #4
        I could get into some serious trouble with that Kart!
        Proud owner of a MM180!