Tweet
I am welding 304 SS to inconel. 1/4 ss flat and 2x2 angle ss, to 5/16 inconel. i am using AG 25 with CHFM 15. using 045 flux core to weld and i am at the proper setting with the miller. there are a ton of cracks. anyone give up a secret i could use it.
-
-
"Better Metalworking Through Research"
Miller Dynasty 300DX
Miller Dynasty 200DX
Miller Spectrum 375 extreme
Miller Millermatic Passport
Miller Spot Welder
Motor-Guard stud welder
Smith, Meco, Oxweld , Cronatron, Harris, Victor, National, Prest-o-weld, Prest-o-lite, Marquette, Century Aircraft, Craftsman, Goss, Uniweld, Purox, Linde, Eutectic, and Dillon welding torches from 1909 to Present. (58 total) -
I think the best way would be tig welding with an inco wire. Inco 82 is a pretty versitle wire. Inco 625 may work also.
If you can't tig weld it then maybe mig it with the inco wire.Comment
-
i will finish with inco wireComment
Comment