Announcement

Collapse
No announcement yet.

Airco msm250 ac/dc

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Meltedmetal
    replied
    It allows for the pin and/or socket to wear some and still go in until tight.


    ---Meltedmetal

    Leave a comment:


  • chub380
    replied
    Ok so about 3/8” of the stud will not go in? I was thinking it would almost go up to the insulation on the handle. So this is perfectly normal?

    Leave a comment:


  • Weld dr
    replied
    yes that is normal the plug and the recp. are tapered.

    Leave a comment:


  • chub380
    started a topic Airco msm250 ac/dc

    Airco msm250 ac/dc

    Hello fellas, just picked up this old airco machine. Thought it would be a good one for people who stop by to use. Anyhow I never used this style of pins that connect to the machine,seems like they must have a slight taper or at least the sockets might. But they don’t go the whole way in I want to say you might be able to see a 1/4” of the pin when it’s tight is this normal? Anyway it’s been fun cleaning it up and going over it. I can’t get over how heavy it is for such a small box it has to weigh a couple hundred pounds. Thanks for any insight
    Last edited by chub380; 08-02-2022, 11:33 PM.
Working...
X