Announcement

Collapse
No announcement yet.

Synchrowave 250 losses welding current but still has high frequency and gas flow

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 1997CST
    replied
    Do you have the timers correctly positioned? If so sounds like a loose connection on a cable inside. Heating up, separating and losing current.

    Leave a comment:


  • G-ManBart
    replied
    The pros here will want to know your serial number to be able to look at the correct schematics.

    Leave a comment:


  • Synchrowave 250 losses welding current but still has high frequency and gas flow

    My Synchrowave 250 welds for a couple of minutes and then loses welding current. The high frequency stays on and the gas flows. If I stop welding for a few minutes it will weld again for a few minutes. I am welding some .062 aluminum sheet, current is set at about 25% of max.
    Anybody have any ideas?
Working...
X