No announcement yet.

Help Dynasty 300 DX

  • Filter
  • Time
  • Show
Clear All
new posts

  • Help Dynasty 300 DX

    I moved the machine from California to Texas in a U-Haul. It was working fine before the move & now it will not give me full amps in TIG mode. I have it set to 300 amps but will only give me 90 amps, if I set it to stick mode it gives me the full 300 amps. I have checked the foot pedal from my 300 DX on my 200 DX & it works fine. I put the pedal off of my 200 DX on the 300 DX & it has the same problem. Has anyone had this type of problem before? if so is there a simple solution? Thank you for any assistance.