Announcement

Collapse
No announcement yet.

Spectrum 375 X amp problem

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • cruizer
    replied
    its usually a bit of moisture in the gun. What i do is take out and run the electrode and it's tip on some concrete. usually fires right up. as well don't crank the nozzle on too tight.

    Leave a comment:


  • blue_tech
    replied
    If you give me the serial number I can be more accurate, but if it is the one I think you are talking about, we would need to measure the output command signal from the front panel board to the control board. This is usually a 0-5 VDC signal.

    Leave a comment:


  • mikeswelding
    started a topic Spectrum 375 X amp problem

    Spectrum 375 X amp problem

    My 375, which had been working just fine, will now only cut about 1/16" mild steel, even though it is connected to 240 and all other conditions, like ground and air pressure, are good. It also doesn't seem to make any difference what the amp setting is.

    Any thoughts or solutions would be greatly appreciated.
Working...
X